污水處理設備 污泥處理設備 水處理過濾器 軟化水設備/除鹽設備 純凈水設備 消毒設備|加藥設備 供水/儲水/集水/排水/輔助 水處理膜 過濾器濾芯 水處理濾料 水處理劑 水處理填料 其它水處理設備
眉山新建華通信技術有限公司
參 考 價 | 面議 |
產品型號KT-50
品 牌
廠商性質其他
所 在 地
聯系方式:張先生查看聯系方式
更新時間:2025-02-26 09:34:27瀏覽次數:26次
聯系我時,請告知來自 環保在線●意大利克洛特納儀表公司生產的KLORTNER紙張水分儀,能通過簡單的接觸,快速測量出50~500g/m2之間的各種紙張、紙箱、瓦楞紙等的含水率,且不損壞被檢測的材料?!竦碾姶挪▊鞲屑夹g(shù)能穿透紙張深度達50mm,產生一個三維立體磁場進行現場測量。因此,它是準確度的紙張測濕儀表?!駜x表開機后40秒自動關機,有效節約電能,保護儀器更長時間的使用?!駜x器設有低電壓顯示,當
一、技術指標
1、測量范圍:2~50%
2、顯示:LCD液晶顯示
3、檔位調整:50~
4、掃描深度:0~
5、精度:±0.5%
6、體積、重量:120×60×26(mm),
二、使用方法
選擇檔位開關:
1檔:紙箱、瓦楞紙板
2檔:
3檔:瓦楞紙、書寫紙、牛皮紙、箱板紙
4檔:新聞紙、白板紙、涂布紙
5檔:銅版紙、復印紙、傳真紙
由于紙張結構不同,其介電系數亦不同;以上檔位為建議檔位,如有誤差,請進行對比校驗。如:測量某一已知水分為8%的紙張,調整檔位開關為4檔時,所測數字顯示為08.0,則以后再測量同類紙張時應將檔位選為4檔。
三、注意事項
1、由于KT-50型紙張水分儀電磁波穿透深度達
2、如儀表開機后顯示不在00.0±00.5范圍以內,請將電池后蓋打開取出電池,在電池盒內側有一零位調節器。正值不到零位,逆時針調節;反之,順時針調節。
3、由于本紙張水分儀采用電磁波感應方式進行測量,測量時儀器周圍或底部不得有金屬物或其它感應物,否則會對測量精度有所影響。
PAPER MOISTURE TESTER KT-50
Introduction
The electronic meter allows the measurement of the moisture in the paper in the size 120×60×
FEATURES
KT-50 paper moisture meter produced by Italy KLORTNER company permits to measure the moisture content of many kinds of paper products ranging from 50 to
The precise dielectric constant measurement with HF waves can get the moisture content of the depth of
After being used for 40 seconds,KT-50 moisture meter will automatically turn off to retrench the power supply for protecting itself.
KT-50 paper moisture meter will remind you of low voltage as well.
TECHNICAL DATA
Measuring Range:0%~50%
Resolution:0.1%
Repetition Accuracy: ±0.5%
Display:3½LCD
Scanning Depth:
Work Environment:
Power Supply:9V(
Dimension:120×60×
Weight:
APPLICATION
Before measuring,get a right selector according to the paper species table or paper density.
With the sensor of KT-50 touching nothing,press“ON"button.Turn carefully“ZERO"button in the battery cover,till the readings on the screen is between 00.0±00.5.
With the sensor of the meter,touch the wood to be measured fully.As soon as the meter is in touch with the paper surface,the moisture content is indicated.
NOTICE
The paper to be measured should be bigger than the sensor of the meter.
Nothing else can be placed under the paper to be measured,otherwise the measurement will be inaccuracy.
If the thickness of the material to be measured is lower than
您感興趣的產品PRODUCTS YOU ARE INTERESTED IN
環保在線 設計制作,未經允許翻錄必究 .? ? ?
請輸入賬號
請輸入密碼
請輸驗證碼
請輸入你感興趣的產品
請簡單描述您的需求
請選擇省份
聯系方式
眉山新建華通信技術有限公司